High Performance Products. Worldwide Marketing And Distribution. Parabeam Driveway Alarm / Perimeter Alarm Systems. Blue Eye Infrared Remote Extender / Repeater / Distribution Systems


Contact Us Here
Tel: 01904 295 250
Overseas: 00 44 7590 832295

Home Page

Parabeam Products
Blue Eye Products
Related Links
 


InstallationFarm SecurityFAQProducts & PricesTestimonials


Parabeam 700-fsk Driveway and Perimeter Alarm Systems | Farm Security Sysstems | Compound Security

How easy is it to install the Parabeam 700-fsk?

The answer is....... extremely easy DIY install! Just eight simple steps
We would also advise to read through the full manual before installing to further familiarise yourself with the complete system. 

Tools required:

Screwdriver - #2 Philips (cross headed) - to remove / replace the enclosure front covers.
Screwdriver - Small flat electrical - to connect the solar panel wires.
Cable Strippers or Side Cutters - to strip the outer solar panel cable and bear the inner wires.
8mm Socket + Ratchet + Extension - to fit enclosure swivel brackets and attach enclosures to mounting.

 

 

Parabeam 700-fsk beam enclosure with swivel bracket attached | Parabeam wireless driveway and perimeter alarm systems

 

Internal sketch of Parabeam 700-fsk wireless security beam | Internal rechargeable battery pack is constantly topped up via small remote solar panel

Parabeam 700-fsk swivel brackets are already fitted
but you may need change the position of the fixing bracket depending
on the surface you want to mount the enclosure to.
Solar panel wires are also pre-connected. If the cable requires shortening or lengthening, the wires should be reconnected and routed as shown in the diagram.
The internal battery is installed but NOT connected on arrival and should be connected prior to the alignment test.

Point to point infrared beam is completed by aligning both enclosures at the same height and facing each other | Infrared beam can span up to 40m

The remote solar panel comes with 5m cable to allow the best positioning to be able to face up to open area of sky

The wireless security beam is mounted at hip height to be able to detect people and vehicles but ignore small animals, flying birds and peripheral movement.
The beam emitter can be adjusted to produce the beam length -
up to 10m, up to 25m and up to 40m.
Mount the security beam emitter and communicator (the one with the antenna) so the they are visually straight and squarely facing each other.
The solar panel swivel bracket is already fitted and 5m of weatherproof cable attached.
It is important to find a position which allows the panel to face flat up to open sky and avoid shading on any side.
The cable may be lengthened by another 10m if needed to gain the best position.
 

Alignment process is very easy and does not require pin-point accuracy

The Parabeam long range wireless receiver has many features and is available with 2 zones or 4 zones

Connect the batteries to the socket on the circuit board and re-fit the
front covers.
Alignment is simple. From the left side of the communicator, gradually cover the beam window until the yellow LED flashes which signifies the beam is broken. Do the same from the right side of the window and compare the positions at which the yellow LED flashes. If it's roughly
the same you're done!
Attach the Base receiver's antenna as per manual.
Plug in the receiver's mains adapter and switch on.
The beam/s is pre-coded to the base receiver and immediately ready for use.
Pass through the beam to test.
 
Recommended Local Installers
 
     
North Yorkshire        
York Ray Brearton Mobile: 07590 832295   ray@parabeam.co.uk
         
Harrogate Paul Evans Mobile: 07968 007486 Office: 01765 605695 paul@Hg-electrical.co.uk
         
West Yorkshire        
Leeds Paul Helm Mobile: 07743 816610 Office: 01132 406111 paul@kerridgehelm.co.uk
         
South Yorkshire        
Barnsley Mark Roberts Mobile: 07875 557189   mark@mresuk.com
         
Derbyshire        
Ilkeston Chris Timms Mobile: 07976 660397 Office: 0800 4488341 chris@cjtimms.co.uk
         
Nottinghamshire        
Southwell Automation 2000   Office: 01636 812598 automation2000@btconnect.com
         
Shropshire        
Ludlow Kevin Addis Mobile: 07931 188665 Office: 01584 875769 Kevinjaddis@aol.com
         
Gloucestershire,        
Nottingham Richard McShane Mobile: 07931 373223   richard@room57.com
         
Herefordshire        
Clyro Clive Meredith Mobile: 07831 519962   clive@cameredith.f9.co.uk
         
East Anglia        
Gislingham Malthouse Security Ltd Mobile: 07817 073912 Office: 01379 890606 petergeorge@malthouse-security.co.uk
         
Kent        
Ashford Ashford Security Mobile: 0786 7848695 Office: 01233 635263 info@ashfordsecurity.com
         
Berks, Bucks & Oxfordshire        
Maidenhead SeND Technology Ltd SeNDtech Website Office: 01628 638557 sales@sendtech.co.uk